Steering Knuckle

HINT:

• Use the same procedure for the RH side and LH side.
• The procedure listed below is for the LH side.

1. REMOVE FRONT AXLE ASSEMBLY

HINT:

Refer to procedures up to "Remove Front Axle Assembly" (See page ).

2. REMOVE FRONT LOWER BALL JOINT

3. REMOVE FRONT NO. 1 WHEEL BEARING DUST DEFLECTOR

4. REMOVE FRONT AXLE HUB HOLE SNAP RING

5. REMOVE FRONT AXLE HUB SUB-ASSEMBLY

6. REMOVE FRONT DISC BRAKE DUST COVER

7. REMOVE STEERING KNUCKLE

(a) Place the bearing inner race (outside) on the front axle hub bearing.

(b) Using SST, V-blocks and a press, remove the front axle hub bearing from the steering knuckle. If the steering knuckle cannot be kept level using SST, stabilize the steering knuckle using a washer or an equivalent tool. Text in Illustration *1 V-block SST: 09527-21011 SST: 09950-60010 09951-00440 09952-06010 SST: 09950-60020 09951-00750 SST: 09950-70010 09951-07100 NOTICE: Keep the steering knuckle level.

HINT:

• Use the same procedure for the RH side and LH side.
• The procedure listed below is for the LH side.

1. INSTALL STEERING KNUCKLE

(a) Using SST and a press, install a new front axle hub bearing to the steering knuckle. SST: 09950-60020 09951-00810 SST: 09950-70010 09951-07100

2. INSTALL FRONT DISC BRAKE DUST COVER

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY

4. INSTALL FRONT AXLE HUB HOLE SNAP RING

5. INSTALL FRONT NO. 1 WHEEL BEARING DUST DEFLECTOR

6. INSTALL FRONT LOWER BALL JOINT

7. INSTALL FRONT AXLE ASSEMBLY

HINT:

Refer to the procedures from "Install Front Axle Assembly" (See page ).