Toyota Venza: Transfer Case Front Oil Seal(for Rh Side)

Components COMPONENTS ILLUSTRATION

Replacement REPLACEMENT PROCEDURE

1. DRAIN TRANSFER OIL

(a) Remove the transfer drain plug and gasket to drain the transfer oil.

(b) Install a new gasket and the transfer drain plug.

Torque:

49 N·m {500 kgf·cm, 36 ft·lbf}

2. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

(See page ).

3. REMOVE TRANSFER CASE FRONT OIL SEAL

(a) Using SST, remove the transfer case front oil seal from the transfer case.

SST: 09308-00010

NOTICE:

Do not damage the oil seal contact surface on the case.

4. INSTALL TRANSFER CASE FRONT OIL SEAL

(a) Using SST, drive in a new transfer case front oil seal into the transfer case until it reaches the position shown in the illustration.

SST: 09950-60010

09951-00350

09951-00580

09952-06010

SST: 09950-70010

09951-07150

Drive in depth:

33.5 to 34.5 mm (1.319 to 1.358 in.)

NOTICE:

Do not tilt the oil seal during installation.

(b) Apply a small amount of MP grease to the lip of the oil seal.

5. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

(See page ).

6. ADD TRANSFER OIL

7. INSPECT TRANSFER OIL

Transfer Case Front Oil Seal(for Rh Side)