Electrical system, general information

Dealing with problems with Midtronics -INC 940- battery tester

~1min read

Under certain circumstances, the display may show errors or messages according to status. The most frequent display messages are listed below, together with suggested solutions. Note

For messages not listed here, please refer to → operating manual INC 940.

Display message Measures
Check connection.
  • Check whether terminals of battery charger are firmly connected to battery terminals.
  • Check battery terminals are tightened according to regulations and do not have corrosion.
Terminals connected? Safety function of tester.
  • Connect terminals to battery before starting charging procedure.
System noise
  • Switch off all electrical consumers.
  • Wait until all electrical loads monitored by onboard supply control unit have switched off.
  • Remove ignition key.
  • Disconnect any suspect non-standard electrical equipment from the onboard supply.

Wait a few minutes and repeat charging procedure → Chapter.

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.