Installation location: on hydraulic unit, on passenger side of engine compartment. Do not separate connector before successfully completing self-diagnosis. Switch ignition off before separating connector.
The following components are integrated into the control unit:
Control unit for electromechanical parking brake -J540-
Lateral acceleration sender -G200-
Yaw rate sender -G202-
Longitudinal acceleration sender -G251- (depending on equipment fitted)
The components cannot be renewed individually.
Assembly overview → Chapter.
Removing and installing → Chapter
2 -
ABS hydraulic unit -N55-
Fitting location: on passenger side of engine compartment
The hydraulic unit consists of the components:
ABS hydraulic pump -V64-
Brake pressure sender -G201-
Valve block (contains inlet and outlet valves).
ABS hydraulic pump -V64- and valve block must not be separated from one another.
Assembly overview → Chapter.
Removing and installing → Chapter
3 -
Brake pad warning lamp -K32-
Location: in dash panel insert.
4 -
ABS warning lamp -K47-
Location: in dash panel insert.
5 -
ESP and TCS warning lamp -K155-
Location: in dash panel insert.
6 -
Brake system warning lamp -K118-
Location: in dash panel insert.
7 -
Diagnostic connection
Location: Driver footwell cover.
8 -
Steering angle sender -G85-
Fitting location: in steering rack.
The steering angle sender -G85- cannot be renewed separately.
