Brake system
Removing and installing brake caliper, front brakes PC57 and C60
Special tools and workshop equipment required |
|
|
Torque wrench -V.A.G 1331- |
|
 |
Brake pedal depressor -V.A.G 1869/2- Note This procedure applies only to exchanging or the following repair work on the brake caliper. Removing
- Remove front wheel on relevant side.
- Disconnect connector for brake pad wear indicator.
|
|
 |
- Connect bleed bottle bleed hose -1- to bleed valve of brake caliper.
- Open bleed valve.
|
|
 |
- Apply brake pedal depressor -V.A.G 1869/2-.
- Close bleed valve and remove bleed bottle.
- Unscrew brake hose.
|
|
 |
- Unscrew both securing bolts from brake caliper, counterholding on guide pin.
- Pull brake caliper off brake carrier.
Installing
Install in reverse order of removal, observing the following:
Piston is pressed back.
The two brake pads are seated in the retaining springs on the brake carrier.
- Carefully place brake caliper on brake carrier.
- Secure brake caliper to brake carrier with new self-locking bolts, counterholding on guide pin.
- Screw brake hose onto brake caliper.
- Remove brake pedal depressor -V.A.G 1869/2-.
- Connect brake pad wear indicator connector.
- Bleed brake system → Chapter.
- Fit wheel.
Specified torques
→ Chapter „Assembly overview - front brakes PC57 and C60“
Bleed valve → Chapter „Assembly overview - front brake caliper“
Wheel bolts → Running gear, axles, steering; Rep. gr.44. Note Firmly depress brake pedal several times with vehicle stationary so that the brake pads are properly seated in their normal operating position. Check brake fluid level. |
|
 |
?
Test yourself
A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?