Volkswagen Golf Quiz
Electrical system, general information

Removing and installing cigarette lighter socket

In this manual: Electrical system, general information
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~2min read
Note The removal and installation procedure is the same for all sockets and is therefore described here only for the cigarette lighter socket.
Caution If excessive force is exerted on sockets without illumination, the retaining sleeve may be damaged. Only illuminated sockets (cigarette lighter) can be removed with the puller T 40148. The puller does not manage to release the locking lugs of sockets without illuminated retaining sleeve.

Usually sockets without illumination cannot be removed without being damaged.

Special tools and workshop equipment required

Puller -T 40148-

Removing:

  • Remove cigarette lighter, dummy cigarette lighter etc. from socket if necessary.
Note

For reasons of clarity, the socket is removed in the illustration.

Caution

The socket or the retaining sleeve can be damaged.

Ensure that the puller is seated correctly, otherwise the retaining lugs of the retaining sleeve will not be released.
Removing and installing cigarette lighter socket
  • Push puller -arrow- into socket so that locking lugs -1- engage in recesses -2-.
Removing and installing cigarette lighter socket
  • Pull grip -3- in direction of -arrow- to release locking lugs of retaining sleeve.
  • Pull socket out of retaining sleeve using puller.
Caution

The socket wiring can be damaged.

Take care not to stretch the wiring when pulling out the socket.
Removing and installing cigarette lighter socket
Depending on the fitting location, it is recommended to use the thrust piece 40148/1 -2- with the knurled nut -1-.
Caution

Ensure that no surrounding components are damaged when using the thrust piece.
  • Pull off socket connector.
Note Depending on the space requirement, the vehicles are equipped with various electric sockets and cigarette lighter sockets. They differ in length and have different electrical connections. In the case of electric sockets or cigarette lighter sockets with a wiring tail, it may be necessary to perform additional work in order to gain access to the connector.
Removing and installing cigarette lighter socket
  • Release puller locking lugs by pressing spindle -1- in direction of -arrow B-. Then release puller -2- by turning it briefly to left -arrow A-. Remove puller from socket.
Note

Ensure that the puller locking lugs are not spread.

Caution The cigarette lighter might be ejected out of the socket after the heating phase. When the puller is mounted, the socket retaining springs are pressed apart and the retaining force is reduced. After removing the socket, carefully press the retaining springs together and check if the cigarette lighter remains in the removal position after the heating phase.
Removing and installing cigarette lighter socket
  • Carefully press socket retaining springs together -arrows-.
  • Check if cigarette lighter remains in removal position after heating phase and ensure it is not ejected in vehicle interior.

Installing:

Install in reverse order of removal.
Removing and installing cigarette lighter socket

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.