Volkswagen Golf Quiz
Heating, air conditioning

Removing and installing left vent temperature sender -G150

In this manual: Heating, air conditioning
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read

Special tools and workshop equipment required

Vehicle diagnostic tester

Removing

Note Only on vehicles with Climatronic. On vehicles with heater or air conditioning system with electric/manual controls, the apertures in the air ducts are sealed with plugs.

The illustration shows a left-hand drive vehicle. The procedure is identical.

  • Remove dash panel end cover → General body repairs, interior; Rep. gr.70.
  • Turn vent temperature sender -1- in -direction of arrow- and pull it out of mounting.
  • Disconnect electrical connector -2-.

Installing

Installation is carried out in the reverse order. When installing, note the following:
Removing and installing left vent temperature sender -G150
  • Renew seal -3- if damaged or defective.
Note

An incorrectly installed vent temperature sender will cause flow noise.

  • As a final step, read event memory, and erase any entries displayed using vehicle diagnostic tester in “Guided fault finding” mode.

Specified torque

Dash panel; Removing and installing dash panel end cover → General body repairs, interior; Rep. gr.70
Removing and installing left vent temperature sender -G150

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.