Removing and installing mounting bracket, RHD vehicles

Removing

• Remove wiper arms → Electrical system; Rep. gr.92.
• Remove plenum chamber cover → General body repairs, exterior; Rep. gr.50.
• Remove wiper motor -V- → Electrical system; Rep. gr.92.

• Remove bolt -1-.
• Remove dash panel end cover on driver side → General body repairs, interior; Rep. gr.70.
• Remove footwell cover on driver side → General body repairs, interior; Rep. gr.68
• Remove storage compartment on driver side → General body repairs, interior; Rep. gr.68
• Remove dash panel cover on driver side → General body repairs, interior; Rep. gr.68.
• Remove knee airbag → General body repairs, interior; Rep. gr.69.

• Remove footwell vent -1- on driver side → Heating, air conditioning system; Rep. gr.87.
• To do this, unscrew bolt -2- and remove footwell vent on driver side -1-.
• Unbolt crash bar for brake pedal and lay it to one side → General body repairs, interior; Rep. gr.70.
• Separate brake pedal from brake servo → Chapter.

• Release connectors -arrows- and pull off.
• Remove accelerator pedal module -1- from mounting bracket -2- → Rep. gr.20.

• Unclip wiring harness -2- from mounting bracket -1--arrows-.

• Remove nuts -arrows- from mounting bracket -1-.

• Secure brake servo -1- against falling.

Installing

Install in reverse order of removal, observing the following:

• Ensure to route wiring harness -2- correctly so that it is not trapped.
• Clip wiring harness -2- to mounting bracket -1--arrows-.
• Connect brake pedal to brake servo → Chapter.

Specified torques

→ Chapter „Assembly overview - brake pedal, RHD vehicles“

Crash bar → General body repairs, interior; Rep. gr.70.

Footwell vents → Heating, air conditioning system; Rep. gr.87.

Knee airbag → General body repairs, interior; Rep. gr.69.

Covers on driver side → General body repairs, interior; Rep. gr.68

Windscreen wiper system → Electrical system; Rep. gr.92

Plenum chamber cover → General body repair, exterior; Rep. gr.50