Volkswagen Golf Quiz
Running gear, axles, steering

Removing and installing rear body acceleration sender -G343-

In this manual: Running gear, axles, steering
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read
0102030405086N·mlb·ft
Tightening torque found on this page

Special tools and workshop equipment required

Torque wrench -V.A.G 1410-

Removing

  • Remove left luggage compartment side trim → General body repairs, interior; Rep. gr.70.
Removing and installing rear body acceleration sender -G343-
  • Release electrical connector -1- and pull off.
  • Unscrew bolt -2-, and remove rear body acceleration sender -G343--3-.

Installing

Install in reverse order of removal, observing the following:
Removing and installing rear body acceleration sender -G343-
  • Insert rear body acceleration sender -G343--1- so that lug -arrow A- engages into hole -arrow B-.
  • Perform basic setting of wheel damper electronics → Vehicle diagnostic tester.

Specified torques
Removing and installing rear body acceleration sender -G343-
Component Specified torque
Rear body acceleration sender -G343- to body 8 N·m

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.