Volkswagen Golf Quiz
Brake system

Removing and installing speed sensors on front axle -G45-/-G47

In this manual: Brake system
General body repairs, exterior — 230General body repairs, interior — 279General information, paint — 133Vechile- specific paint information — 27Heating, air conditioning — 156Auxiliary heater — 58Air conditioning system with refrigerant R134a — 1297- speed dual clutch gearbox 0CW — 544- cylinder injection engine(1.4 1 direct inction. turbocharger) — 182Fuel supply system - Petrol engines — 59Running gear, axles, steering — 221Brake system — 92Wheels and Tyres guide — 12Guide for using trailers — 11Wheels and Tyres Guide - General Information — 121Brake system (hybrid) — 73Electrical system — 326Communication — 65Electrical system, general information — 111
~1min read
Note Removal and installation is described for the front left speed sensor. Removal and installation of the front right speed sensor is analogous.

Removing

  • Raise vehicle.
  • Disconnect connector -3- from front left speed sensor -G47--1-.
  • Unscrew bolt -2-, and pull front left speed sensor -G47--1- out of wheel bearing housing.

Installing

Install in reverse order of removal, observing the following:

  • Clean inside surface of hole before inserting speed sensor.
  • Coat speed sensor all-round with high-temperature paste G 052 112 A3.

Specified torque

→ Chapter „Assembly overview - speed sensor on front axle“
Removing and installing speed sensors on front axle -G45-/-G47

Test yourself

A quick Volkswagen Golf quiz: every answer comes with an explanation and a link to the manual page.