Removing and installing starter, vehicles with double clutch gearbox (DQ250-6F)

Special tools and workshop equipment required

Torque wrench -V.A.G 1331-

Torque wrench -V.A.G 1332-

Removing

• With ignition switched off, disconnect earth cable from battery -A- → Chapter.

Vehicles with air filter housing installed in front of battery

• Remove air filter housing → Rep. gr.23.

Continued for all vehicles

• Remove noise insulation → General body repairs, exterior; Rep. gr.66.

• If installed, unscrew nut -2- from lower bolt for starter -B--1-.
• If fitted, remove earth cable -3-.
• Remove bolt -4- for starter -B--1-.

• If fitted, unscrew nut -1- from upper securing bolt of starter -B-.
• If fitted, remove earth cable -2-.

• Disconnect electrical connector -3-.
• Press off cap -4-.
• Unscrew nut -5- and remove terminal 30/B+.
• Remove bolt -1- for starter -B--2-.
• Remove starter -B--2- upwards.

Installing

Install in the reverse order of removal, observing the following:

Specified torques

→ Chapter „Assembly overview - starter“

• Reconnect battery -A- → Chapter.

Cruise control system (CCS)