Service interval display
and safety warnings first⇒
to the topic
Service event information is shown in the instrument cluster display ⇒ Fig. 10 or ⇒ Fig. 11②.
Volkswagen service appointments are divided into oil change service and inspections. The service interval display only indicates service appointments that include an engine oil change. All other service appointments, such as the next due inspection or a brake fluid change, are listed in the service plan.
Fixed service intervals with fixed oil change service are specified.
Service eventWhen an oil change service is due, an audible signal sounds when the ignition is switched on, and a service reminder appears for several seconds in the form of the abbreviation![]()
![]()
![]()
.
Volkswagen recommends having the due service performed within the next 100 km (about 62 miles) of driving.
If the service was not performed by a Volkswagen Partner, the display in the instrument cluster can be reset as follows:
| Switch off the ignition. |
| Button Press and hold the button in the instrument cluster. |
| Switch the ignition back on. |
| Button Release, then press briefly again within about 10 seconds. |
Do not reset the service interval display between service intervals, as this will cause incorrect displays.
The service message goes out after a few seconds
with the engine running, or by pressing the button![]()
![]()
on the wiper lever ⇒ Fig. 12①.
If the vehicle battery has been disconnected for an extended period
, it is not possible to calculate the time until the next service is due. The service displays may therefore show incorrect calculations. In this case, observe the maximum permitted maintenance intervals ⇒ booklet Service Plan.