Fuel Supply - Petrol Engines

Technical Data

~2min read

Safety Information

Safety Precautions when Working on the Fuel Supply

Risk of injury from fuel under high pressure

The fuel system is under high pressure. Injury from spraying fuel possible.

- Before opening the fuel system, relieve fuel high pressure.

Procedure for relieving fuel high pressure.

Fire hazard from escaping fuel

With the battery connected, the door contact switch activates the fuel pump when the driver's door is opened. Escaping fuel can ignite and cause a fire.

- Before opening the fuel system, disconnect the power supply to the fuel pump.

Safety Precautions for Test Drives with Test and Measuring Equipment

Risk of injury from unsecured test and measuring equipment

In an accident in which the front passenger airbag deploys, inadequately secured test and measuring equipment becomes a dangerous projectile.

- Secure test and measuring equipment on the rear seat with seat belts.

Or

- Have a second person operate the test and measuring equipment on the rear seat.

Safety Precautions when Working on Vehicles with Start-Stop System

Risk of injury from unexpected engine start

On vehicles with the start-stop system activated, the engine may start unexpectedly. Whether the start-stop system is activated can be seen from a message in the instrument cluster.

- To deactivate the start-stop system: switch off the ignition.

Identification

Engine Number/Engine Characteristics

VW UP. Motornummer/Motormerkmale

1) in exceptional cases at least 91 RON, but reduced output.

General Information

Cleanliness Rules for Work on the Auxiliary/Additional Heater and Fuel System

When working on the fuel supply/injection, observe the following "rules":

  • Thoroughly clean connection points and their surroundings before disconnecting.
  • Place removed parts on a clean surface and cover them. Do not use lint-producing rags!
  • Carefully cover or seal opened components if the repair is not carried out immediately.
  • Only install clean parts: remove replacement parts from their packaging only immediately before installation. Do not use parts that were stored unpackaged (e.g. in tool boxes, etc.).
  • Do not use compressed air when the system is open.
  • Do not move the vehicle.
  • Immediately seal open lines and connections with clean plugs, for example from the engine blanking plug set -VAS 6122-.
  • Protect disconnected electrical connectors from dirt and moisture and only connect them when dry.