Brake system

Technical Data

~1min read

Brake test

Testing vehicles with front-wheel drive

The brake test must be performed on a single-axle roller brake tester.

The test speed must not exceed 6 km/h.

Test stands approved by Volkswagen meet these requirements.

General Information

  • The drive is provided by the test stand.
  • During the test, select neutral on vehicles with manual transmission and position "N" on vehicles with automatic transmission.
  • Observe the test stand manufacturer's instructions during the test.


Note

With ignition off, the brake control systems are not functional.

Identification

Assignment of PR number - brake

The brake fitted to the vehicle is documented, among other places, on the vehicle data carrier by the corresponding PR number.

In this example, the following brake is fitted to the vehicle:

  • Arrow 1 - Rear brake - 1KM
  • Arrow 2 - Front brake - 1LA

The vehicle data carrier is located in the spare wheel well and in the service plan.

The table below shows a breakdown of the PR numbers. These are important for the combination of brake caliper/brake disc/brake drum and brake pad.

  • Assignment → Electronic Parts Catalogue (ETKA)
VW UP. Bremsanlagen

Rear brakes

Drum brake


Front brakes


Technical Data

Brake technical data

Brake master cylinder and brake booster


Rear brake (drum brake)

VW UP. Bremsanlagen


Front brake FS III

VW UP. Bremsanlagen