Checking the fuses

The following procedure applies to all of the fuses.

To avoid a short circuit, always turn the main switch to "OFF" when checking or replacing a fuse.

1. Remove:

• Rider seat Refer to "GENERAL CHASSIS" on page 4-1.

2. Check:

• Fuse

a. Connect the pocket tester to the fuse and check the continuity.

Set the pocket tester selector to " × 1".

b. If the pocket tester indicates " ", replace the fuse.

3. Replace:

• Blown fuse

a. Set the main switch to "OFF".

b. Install a new fuse of the correct amperage rating.

c. Set on the switches to verify if the electrical circuit is operational.

d. If the fuse immediately blows again, check the electrical circuit

Never use a fuse with an amperage rating other than that specified. Improvising or using a fuse with the wrong amperage rating may cause extensive damage to the electrical system, cause the lighting and ignition systems to malfunction and could possibly cause a fire.

4. Install:

• Rider seat Refer to "GENERAL CHASSIS" on page 4-1.