Chassis

Control Arm Ball Bearing, Replacing

~3min read

Control Arm Ball Bearing, Replacing, Wheel Bearing Housing Side

Special tools and workshop equipment required

  • Press Plate -VW402-
  • Press Piece - Multiple Use -VW412-
  • Press Piece - 42mm -VW516-
  • Press Piece - Reverse Gear Syncro -3296-
  • Assembly Paste -G 052 109 A2-

Procedure

  • The control arm is removed. Refer to → Chapter "Control Arm, Removing and Installing".

Note

Hold track control arm firmly when removing and installing the bonded rubber bushing.

Pressing Out Bonded Rubber Bushing

- Mark the press-in depth on the bonded rubber bushing -1--arrow-.

Use a waterproof felt-tip pen for marking.

- Install the special tools as shown in the illustration.

- Remove the bonded rubber bushing -1- from the control arm -2-.

A40-10411

Installing Bonded Rubber Bushing

- Transfer the installation depth marking from the old bonded rubber bushing to the new one.

- Thinly coat the bonded rubber bushing with the Assembly Paste -G 052 109 A2-.

- Install the bonded rubber bushing -1- into the control arm -2-.

- Install the special tools as shown in the illustration.

Note

When installing, make sure the bonded rubber bushing does not tilt.

- Install the bonded rubber bushing -1- into the control arm -2-.

- Note the installation depth marking when installing -arrow-.

A40-10412

- Check the press-in depth of the bonded rubber bushing -1- inside the control arm -2-.

Dimensions -a and b- must be identical.

- If the dimensions -a and b- are different, adjust the bonded rubber bushing -1-.

- Install the control arm. Refer to → Chapter "Control Arm, Removing and Installing".

A40-10413

Control Arm Ball Bearing, Replacing, Subframe Side

Special tools and workshop equipment required

  • Shop Press -VAG1290A-
  • Press Piece - Rod -VW407-
  • Bearing Installer - Control Arm -3346-
  • Puller - Differential Bearing -T40032-
  • Press Plate -VW402-
  • Assembly Paste -G 052 109 A2-

Procedure

  • The control arm is removed. Refer to → Chapter "Control Arm, Removing and Installing".

Note

Hold track control arm firmly when removing and installing the bonded rubber bushing.

Pressing Out Bonded Rubber Bushing

- Mark the position of the "kidney" on the bonded rubber bushing on the control arm -arrows- as illustrated.

A40-10571

Use a waterproof felt-tip pen for marking.

- Install the special tools as shown in the illustration.

- Remove the bonded rubber bushing from the control arm.

A40-10557

Installing Bonded Rubber Bushing

- Thinly coat the bonded rubber bushing with the Assembly Paste -G 052 109 A2-.

- Install the bonded rubber bushing into the control arm on the side with the bevel -arrow-.

A40-10572

- Align the position of the "kidney" with the markings -arrows- on the control arm made earlier.

A40-10571

- Install the special tools as shown in the illustration.

Note

When installing, make sure the bonded rubber bushing does not tilt.

- Push the bonded rubber bushing into the control arm.

A40-10557

- Check the press-in depth of the bonded rubber bushing -1- inside the control arm -2-.

Dimensions -a and b- must be identical.

- If the dimensions -a and b- are different, adjust the bonded rubber bushing -1-.

- Install the control arm. Refer to → Chapter "Control Arm, Removing and Installing".

A40-10034