Chassis

Overview - Wheel Bearing

~2min read
0204060801004030N·mlb·ft
Tightening torque found on this page
Overview - Wheel Bearing

1 - Nut

  • 40 N·m
  • Always replace if removed

2 - Upper Front Control Arm

3 - Upper Rear Control Arm

4 - Bolt

  • Always replace if removed

5 - Washer

6 - Wheel Bearing Housing

  • Removing and installing. Refer to → Chapter "Wheel Bearing Housing, Removing and Installing".

7 - Brake Shield

8 - Bolt

  • For the tightening specification. Refer to → Brake System;

9 - Bolt

  • 200 N·m +180º turn
  • Replace after each removal. Refer to → Chapter "Drive Axle General Information".
  • Before installing, clean the threads in the CV joint with a tap.

10 - Wheel Hub

  • Removing and installing. Refer to → Chapter "Wheel Bearing Unit, Servicing".

11 - Wheel Bearing

  • Wheel bearing unit, removing and installing. Refer to → Chapter "Wheel Bearing Unit, Removing and Installing".
  • Removing and installing. Refer to → Chapter "Wheel Bearing Unit, Servicing".

Caution

Avoid contaminating with dirt and damaging the seal when lifting, setting down/storing. Refer to → Fig. "Avoid Contaminating with Dirt and Damaging the Seal When Lifting, Setting Down/Storing.".

12 - Bolt

  • 40 N·m
  • Always replace if removed

13 - Nut

  • 140 N·m
  • Always replace if removed
  • After loosening threaded connection of guide control arm to wheel bearing housing, adhesive residue must be removed on thread of linkage stub.

14 - Control Arm

15 - Nut

  • M12: 120 N·m
  • M14: 140 N·m
  • There are different versions. For allocation. Refer to the Parts Catalog.
  • Always replace if removed
  • After loosening threaded connection on the ball joint to the wheel bearing housing, adhesive residue must be removed on thread of linkage stub.

16 - Guide Link

17 - Tie Rod End

18 - Nut

  • Tightening specification. Refer to → Chapter "Overview - Steering Gear, Steering Gear with Tie Rods"
  • Always replace if removed

19 - Bolt

  • Tightening specification. Refer to → Brake System; Rep. Gr.45.

20 - Wheel Speed Sensor

21 - drive axle

22 - Bolt

  • M10 70 N·m
  • Always replace if removed

23 - Cap Bolts

  • 80 N·m +90º turn
  • Always replace if removed

Avoid Contaminating with Dirt and Damaging the Seal When Lifting, Setting Down/Storing.

  • The wheel bearing -1- must always face up.
  • Always set the wheel bearing unit down on the wheel hub -2-.
A42-10264
  • Never reach into the inside when lifting the wheel bearing.
  • Hold the wheel bearing only on the outside.
A40-10588