Transmission

Final Drive

~2min read
01020304050107N·mlb·ft
Tightening torque found on this page

Overview - Final Drive

Overview - Final Drive

1 - Flywheel

  • Removing and installing. Refer to → Chapter "Flywheel, Removing and Installing".

2 - Shaft Seal

  • For the left flange shaft
  • Between the final drive and the transmission housing
  • Replacing. Refer to → Chapter "Left Seal, Replacing".

3 - Shim

  • Behind the taper roller bearing outer race

4 - Taper Roller Bearing Outer Race

5 - Differential

6 - Bolt

  • Quantity 10
  • Tightening specification and sequence. Refer to → Fig. "Tightening Specification and Sequence, Front Final Drive Cover"

7 - Locking Ring

  • Replacing

8 - Right Flange Shaft

  • Removing and installing. Refer to → Chapter "Right Flange Shaft, Removing and Installing".

9 - Shaft Seal

  • For the right flange shaft
  • Replacing. Refer to → Chapter "Right Seal, Replacing".

10 - Front Final Drive Cover

  • Removing and installing. Refer to → Chapter "Left Seal, Replacing".

11 - O-Ring

  • On the front final drive cover
  • Replacing

12 - Shim

  • Behind the taper roller bearing outer race

13 - Taper Roller Bearing Outer Race

14 - Spring Pin

15 - Gearshift Lever

16 - Shaft Seal

  • For the selector shaft
  • Replacing. Refer to → S tronic Transmission; Rep. Gr.34; Selector Mechanism; Selector Shaft Seal, Replacing

17 - Bolt

  • 10 N·m + 45º
  • Quantity: 3

18 - Left Flange Shaft

  • Removing and installing. Refer to → Chapter "Left Flange Shaft, Removing and Installing".

19 - Bracket

  • Attached to the left flange shaft with the ball bearing -20- and the circlip -21-
  • Check for traces of wear on the bearing bracket and check the pre-tension on the ball bearing for the left flange shaft. Refer to → Chapter "Left Flange Shaft Ball Bearing Pre-Tension, Checking and Adjusting"

20 - Ball Bearing

  • For the left flange shaft
  • Left Flange Shaft Ball Bearing Pre-Tension, Checking. Refer to → Chapter "Left Flange Shaft Ball Bearing Pre-Tension, Checking and Adjusting"
  • Replacing. Refer to → Chapter "Left Flange Shaft Ball Bearing Mounting Bracket, Removing and Installing".

21 - Locking Ring

  • For the left flange shaft bearing
  • Replacing

22 - Shaft Seal

  • For the input shaft
  • Replacing. Refer to → Chapter "Input Shaft Seal, Replacing".

Tightening Specification and Sequence, Front Final Drive Cover

Note

Replace any bolts that were tightened with an additional turn.

- Tighten the bolts in three steps in the sequence shown:

A39-10193
Tighten the bolts in three steps in the sequence shown