Transmission

Seals

~3min read

Left Seal, Replacing

Special tools and workshop equipment required

  • Used Oil Collection and Extraction Unit -SMN372500-
  • Seal Installer - Flange Shaft -T40164-
  • Grease. Refer to the Parts Catalog.

Procedure

  • Secure the transmission on the Engine And Transmission Holder -VAS6095-. Refer to → Chapter "Securing on Engine and Transmission Holder".

- Place the Used Oil Collection and Extraction Unit -SMN372500- under the transmission.

- Remove the right flange shaft. Refer to → Chapter "Right Flange Shaft, Removing and Installing".

- Remove the bolts -arrows-.

- Carefully remove the front final drive cover; when doing this, the transmission fluid will drain out.

Caution

Danger of causing damage to the differential.

  • Slowly and carefully remove front final driver cover from transmission housing. Otherwise differential can fall out of transmission.
  • A differential that has fallen out can no longer be installed. If differential falls out, transmission must be replaced.
  • Make sure the differential bearing inner race and adjustment shims do not fall out of the transmission housing and front final drive cover.
  • Bearing inner races and adjustments that have fallen out cannot be allocated with workshop equipment.
A39-10258

- Carefully remove the differential -arrow- and lay it on a soft support.

- Remove the left flange shaft. Refer to → Chapter "Left Flange Shaft, Removing and Installing".

A37-10157

Caution

Danger of damaging the seating surface in the transmission housing.

Position the screwdriver.

- Pry out the seal from the back.

A39-10194

- Lightly coat the new seal on the outside with oil and install it using the Seal Installer - Flange Shaft -T40164-.

  • The open side of the seal faces the Thrust Piece for Final Drive at Gearbox -T40164-.

- Install the shaft seal for the left flange shaft using the Seal Installer - Flange Shaft -T40164- all the way; when doing this, do not bend it.

- Fill the space between the sealing- and dust lip half way with sealing grease. Refer to the Parts Catalog.

- Install the differential.

A39-10257

- Install the front final drive cover with a new O-ring and tighten the bolts. Refer to → Fig. "Tightening Specification and Sequence, Front Final Drive Cover".

- Install the left flange shaft. Refer to → Chapter "Left Flange Shaft, Removing and Installing".

- Install the right flange shaft. Refer to → Chapter "Right Flange Shaft, Removing and Installing".

- Fill with transmission fluid (MTF). Refer to → S tronic Transmission; Rep. Gr.39; Transmission Fluid; Transmission Fluid, Draining and Filling.

A39-10193

Right Seal, Replacing

Special tools and workshop equipment required

  • Seal Installer - Flange Shaft -T40163-
  • Pry lever
  • Grease. Refer to the Parts Catalog.

Procedure

- Remove the right flange shaft. Refer to → Chapter "Right Flange Shaft, Removing and Installing".

- Pry out the flange shaft sealing ring -arrow-.

- Lightly coat the outer circumference of the new shaft seal with oil.

A39-10259

- Drive in the right flange shaft seal using the Seal Installer - Flange Shaft -T40163- until stop without tilting.

- Fill the space between the sealing- and dust lip half way with sealing grease. Refer to the Parts Catalog.

- Install the right flange shaft. Refer to → Chapter "Right Flange Shaft, Removing and Installing".

A39-10256

Selector Shaft Seal, Replacing

  • The transmission is installed.

Description of the procedure. Refer to → S tronic Transmission; Rep. Gr.34; Selector Mechanism; Selector Shaft Seal, Replacing