Electrical System

Front Interior Lamp/Reading Lamp, Removing and Installing

~2min read

Front Interior Lamp/Reading Lamp, Removing and Installing, without Eyeglass Compartment

Removing

- Remove the interior lamp cover -1- in direction of -arrows-.

A96-10874

- Remove the bolt -1-.

- Move the interior/reading lamp -2- forward and down in direction of -arrow- and disengage it.

- Disconnect the connectors.

Installing

Install in reverse order of removal. Note the following:

- Mount the interior lamp and screw in.

- Press the interior lamp cover until it clicks into place.

A96-10801

Front Interior Lamp/Reading Lamp, Removing and Installing, with Eyeglass Compartment

Removing

- Open the eyeglass compartment -1-.

- Remove the bolt -3-.

- Move the interior/reading lamp -2- forward and down in direction of -arrow- and disengage it.

- Disconnect the connectors.

Installing

Install in reverse order of removal.

A96-10884

Rear Interior/Reading Lamp, Removing and Installing

Special tools and workshop equipment required

  • Wedge Set -T10383-

Removing

- Remove the interior lamp/reading lamp -1- from the roof using Wedge Set - Wedge 1 -T10383/1- in direction of -arrows-.

- Disconnect the connector.

Installing

Install in reverse order of removal. Note the following:

- Insert the interior/reading lamp into the roof cutout and clip it in.

A96-10803

Left/Right Front Reading Lamp Button -E633-/-E634-, Removing and Installing

Special tools and workshop equipment required

  • Trim Removal Wedge -3409-

Removing

- Remove the interior/front reading lamp with the eyeglass compartment. Refer to → Chapter "Front Interior Lamp/Reading Lamp, Removing and Installing, with Eyeglass Compartment".

- Remove the cover -1- from the interior lamp in direction of -arrows-.

- If equipped, remove the rubber piece -2- and open the tabs.

A96-10955

- Remove the interior lamp/reading lamp -1- button -2- in direction of -arrow- using Trim Removal Wedge -3409-.

Installing

Install in reverse order of removal. Note the following:

- Press the new button into the interior/reading lamp.

  • Make sure the springs -3- on the left and right sides of the button fit correctly in the mounts.

- Press the interior lamp cover until it clicks into place.

A96-10939

Garage Door Opener Control Head -E284-, Removing and Installing

Removing

- Remove the front interior/reading lamp. Refer to → Chapter "Front Interior Lamp/Reading Lamp, Removing and Installing".

- Remove the Anti-Theft Alarm System Sensor -G578-, if equipped. Refer to → Chapter "Anti-Theft Alarm System Sensor -G578-, Removing and Installing".

- Carefully push the tabs to the side in direction of -arrows A-.

- Remove the controls -1- from the front interior/reading lamp -2- in direction of -arrow B-.

Installing

Install in reverse order of removal.

A96-10877