Starting and driving
Launch control program
In this manual: Starting and driving
~2min read
Applies to: vehicles with S tronic
The launch control program provides the best possible acceleration when starting from a stop.
Requirement: the engine must be at operating temperature and the steering wheel must not be turned.
- Deactivate the Start/Stop system.
The LED in the
button turns on. - Switch the Electronic Stabilization Control (ESC) sport mode on. The
indicator light turns on. - Pull the selector lever back out of the D/S position briefly to select the S position or select the DYNAMIC driving mode in drive select.
- Press the brake pedal firmly with your left foot and hold it all the way down for at least one second.
- At the same time, press the gas pedal all the way down with your right foot until the engine reaches and stays at a high RPM level.
- Remove your foot from the brake pedal within five seconds.
WARNING
- Always adapt your driving to the traffic flow.
- Only use the Launch control program when road and traffic conditions allow it and other drivers will not be endangered or bothered by your driving and the vehicle's acceleration.
- Please note that the drive wheels can spin and the vehicle can break away when sport mode is switched on, especially when the road is slippery.
- Once the vehicle has started moving, press the
button briefly to turn the sport mode off.
Tips
- The transmission temperature may increase significantly after using the launch control program. If that happens, the program may not be available for a few minutes. It will be available again after a cool-down period.
- When accelerating using the launch control program, all vehicle parts are subject to heavy loads. This can lead to increased wear.
Was this page helpful?