Electrical System

Overview - Windshield Washer System

~2min read
0102030405086N·mlb·ft
Tightening torque found on this page
Overview - Windshield Washer System

1 - Windshield Washer Fluid Level Sensor -G33-

  • Removing and installing. Refer to → Chapter "Windshield Washer Fluid Level Sensor, Removing and Installing".

2 - Grommet

  • Replace if damaged.

3 - Screw

  • Tightening sequence. Refer to → Fig. "Washer Fluid Reservoir - Tightening Specification and Sequence".

4 - Screw

  • Tightening sequence. Refer to → Fig. "Washer Fluid Reservoir - Tightening Specification and Sequence".

5 - Screw

  • 8 N·m

6 - Screw

  • 8 N·m

7 - Filler Tube

  • For the windshield washer fluid reservoir
  • Removing and installing. Refer to → Chapter "Washer Fluid Reservoir Filler Tube, Removing and Installing".

8 - Cap

  • For the filler neck

9 - Water Hose

  • For the windshield washer system

10 - Right Spray Nozzle

  • Vehicle equipment version with Right Washer Nozzle Heater -Z21-
  • Removing and installing. Refer to → Chapter "Spray Nozzles, Removing and Installing".
  • Adjusting. Refer to → Chapter "Spray Nozzles, Adjusting".

11 - Left Spray Nozzle

  • Vehicle equipment version with Left Washer Nozzle Heater -Z20-
  • Removing and installing. Refer to → Chapter "Spray Nozzles, Removing and Installing".
  • Adjusting. Refer to → Chapter "Spray Nozzles, Adjusting".

12 - Grommet

  • For the windshield washer fluid hose inside the hood

13 - Grommet

  • For the windshield washer fluid hose on the fender

14 - Grommet

  • Replace if damaged.

15 - O-Ring

  • Replace if damaged.

16 - Windshield Washer Fluid Reservoir

  • Removing and installing. Refer to → Chapter "Windshield Washer Fluid Reservoir, Removing and Installing".

17 - Securing Tab

  • For the mount inside the fender end plate

18 - Windshield Washer Pump -V5-

  • Removing and installing. Refer to → Chapter "Windshield Washer Pump, Removing and Installing".

19 - Grommet

  • Replace if damaged.

Washer Fluid Reservoir - Tightening Specification and Sequence

- Tighten the washer fluid bolts in the sequence specified:

1. Tighten the bolt -3- to 7 N·m.

2. Tighten the bolt -4- to 7 N·m.

A92-10149