Maintenance and Care
Refilling AdBlue using a bottle
In this manual: Maintenance and Care
~2min read
Applies to: vehicles with selective catalytic reduction
- Remove the cap from the refill bottle
in Filling AdBlue. - Position the bottle on the filler tube and turn the bottle clockwise until it stops turning.
- Press lightly against the bottom of the bottle to empty it. Continue pressing the bottom of the bottle until it is empty or until fluid stops flowing into the tank.
- Remove the bottle and seal the filler neck.
Note
Only use refill bottles that are approved for your vehicle. Using other systems can cause AdBlue to leak.
Tips
- You can obtain refill bottles from an authorized Audi dealer or authorized Audi Service Facility.
- A permitted refill bottle contains approximately 0.5 gallon (1.9 liters) of AdBlue.
Refilling AdBlue using a canister
Applies to: vehicles with selective catalytic reduction
.55.png)
Fig. 179 Canister with attachable hose
- Remove the cover from the refill canister in Filling AdBlue.
- Secure the end of the hose 1 on the opening in the canister A by turning the hose to the right.
- Remove the cap 2 from the other end of the hose B.
- Position the end of the hose 2 on the filler neck in the vehicle and turn the hose to the right to tighten it.
- Lift the canister up and then tip it. Continue holding the canister in a tipped position until it is empty or until no more fluid flows into the tank.
- Remove the canister and close the filler tube.
Note
Only use refill canisters that are approved for your vehicle. Using other systems can cause AdBlue to leak.
Tips
- An authorized Audi dealer or authorized Audi repair facility can tell you which refill canisters are approved for your vehicle.
- A permitted refill canister contains approximately 1.3 gallons (5 liters) of AdBlue.
Was this page helpful?