Chassis

Stabilizer Bar

~2min read
0204060801004030N·mlb·ft
Tightening torque found on this page

Overview - Stabilizer Bar

Overview - Stabilizer Bar

1 - Bolt

  • 40 N·m +90º turn
  • Always replace if removed
  • Must be tightened in the curb weight position. Refer to → Chapter "Wheel Bearing in Curb Weight, Lifting Vehicles with Coil Spring".

2 - Coupling rod

  • Removing and installing. Refer to → Chapter "Stabilizer Bar, Removing and Installing".

3 - Bolt

  • 40 N·m +90º turn
  • Always replace if removed
  • Must be tightened in the curb weight position. Refer to → Chapter "Wheel Bearing in Curb Weight, Lifting Vehicles with Coil Spring".

4 - Nut

  • Always replace if removed

5 - Lower Transverse Link

6 - Subframe

7 - Stabilizer Bar

  • Removing and installing. Refer to → Chapter "Stabilizer Bar, Removing and Installing".
  • The rubber bushing and clamp must not be separated from the stabilizer bar.

8 - Bolt

  • 25 N·m +90º turn
  • Always replace if removed
  • Tighten evenly

Stabilizer Bar, Removing and Installing

Special tools and workshop equipment required

  • Torque Wrench 1331 5-50Nm -VAG1331-
  • Engine and Gearbox Jack -VAS6931-

Removing

Caution

Do not damage the paint on the stabilizer bar when removing and installing.

- Remove the bolt -1-.

Note

  • The threaded connection between the coupling rod and the lower transverse link is under tension.
  • Press the lower transverse link gently downward when removing the bolt -1-.

- Remove the nut -3-, the bolt -2- and the coupling rod -4-.

- Remove the rear section from the exhaust system. Refer to → Rep. Gr.26; Exhaust Pipes/Mufflers; Overview - Muffler.

A42-10372

- Remove the left and right bolts -1-. Then remove the stabilizer bar -2- to the left.

Note

The stabilizer bar -2- is removed and installed completely with the rubber bushings and clamps. Do not remove the clamps and rubber bushings.

Installing

Install in reverse order of removal. Note the following:

Note

  • Bonded rubber bushings have a limited range of motion. Only tighten suspension bolts when vehicle is in curb weight or control position.
  • For lifting the wheel bearing into curb weight position, vehicles with steel suspension. Refer to → Chapter "Wheel Bearing in Curb Weight, Lifting Vehicles with Coil Spring".
  • For vehicles with air spring suspension, lift wheel suspension in control position. Refer to → Chapter "Wheel Bearing in Control Position, Lifting Vehicles with Air Suspension".

- Install the stabilizer bar from the left side.

A42-10373

- Install the left and right bolts -1- so they are still loose and then tighten them evenly.

A42-10373

- Install the coupling rod -4- and bolt -2-.

- Tighten the left and right nuts -3-.

- Tighten the left and right bolts -1-.

- Install the rear section from the exhaust system. Refer to → Rep. Gr.26; Exhaust Pipes/Mufflers; Overview - Muffler.

A42-10372