Starting the Engine

Move the shift lever to P (Park) or N (Neutral). The engine will not start in any other position. To restart the engine when the vehicle is already moving, use N (Neutral) only.

• Do not try to shift to P (Park) if the vehicle is moving. If you do, you could damage the transmission.

Shift to P (Park) only when the vehicle is stopped.

If the steering wheel is turned until it reaches the end of its travel, and is held in that position while starting the vehicle, damage may occur to the hydraulic power steering system and there may be loss of power steering assist.

Starting Procedure

1. With your foot off the accelerator pedal, turn the ignition to START.

When the engine starts, let go of the key. The idle speed will slow down as the engine warms. Do not race the engine immediately after starting it. Operate the engine and transmission gently to allow the oil to warm up and lubricate all moving parts.

The vehicle has a Computer-Controlled Cranking System. This feature assists in starting the engine and protects components. If the ignition key is turned to the START position, and then released when the engine begins cranking, the engine will continue cranking for a few seconds or until the vehicle starts. If the engine does not start and the key is held in START, cranking will be stopped after 15 seconds to prevent cranking motor damage. To prevent gear damage, this system also prevents cranking if the engine is already running.

Engine cranking can be stopped by turning the ignition switch to the ACC/ACCESSORY or LOCK/OFF position.

2. If the engine does not start after five to 10 seconds, especially in very cold weather (below −18 °C or 0°F), it could be flooded with too much gasoline. Try pushing the accelerator pedal all the way to the floor and holding it there as you hold the key in START for up to a maximum of 15 seconds. Wait at least 15 seconds between each try, to allow the cranking motor to cool down. When the engine starts, let go of the key and accelerator.

If the vehicle starts briefly but then stops again, repeat these steps. This clears the extra gasoline from the engine. Do not race the engine immediately after starting it. Operate the engine and transmission gently until the oil warms up and lubricates all moving parts.

See Add-On Electrical Equipment on page 9-47.

Starting the engine in a Chevrolet Captiva First generation is a straightforward process designed for ease and safety. For vehicles equipped with a key ignition system, ensure the vehicle is in Park or Neutral, and engage the parking brake before inserting the key into the ignition switch. Turn the key clockwise to the "Start" position and hold it until the engine starts smoothly, then release the key to the "On" position. Keyless entry systems require depressing the brake pedal (if needed) and pressing the start/stop button until the engine starts, releasing the button once the engine is running.

It's advisable to allow the engine to idle for a brief period after starting, especially in colder weather, to allow for proper lubrication and optimal performance. In case of any starting difficulties, check the battery, fuel level, and refer to the owner's manual for troubleshooting guidance. Following these steps ensures a reliable and hassle-free engine start in 2018 Chevrolet Captiva.