Brake Pedal Position Sensor Calibration

Calibration Criteria

Note: Do not apply the brake pedal during the brake pedal position (BPP) sensor calibration procedure. Any movement of the brake pedal during this procedure will cause the calibration procedure to fail. If this occurs, the sensor calibration must be repeated.

Brake pedal position (BPP) sensor calibration must be performed after the sensor or body control module (BCM) have been serviced. The calibration procedure will set the sensor home value. This value is used by the BCM to determine the action of the driver applying the brake system and to provide this information to the vehicle subsystems via serial data.

Calibration Procedure

1. 1
   Apply the parking brake.
2. 2
   Place the transmission in the PARK position.
3. 3
   Install a scan tool.
4. 4
   Clear all BCM DTCs before proceeding.
5. 5
   Navigate to the Vehicle Control Systems menu.
6. 6
   Select Module Setup menu item.
7. 7
   Select BCM menu item
8. 8
   Select the BPP Sensor Calibration procedure and follow the directions displayed on the screen.

Brake Pedal Position Sensor Replacement

Preliminary Procedure

Remove the instrument panel lower trim pad cover. Refer to Instrument Panel Lower Trim Pad Cover Replacement.

1. Brake Pedal Position Sensor Bolt

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2 N·m

2. Brake Pedal Position Sensor

Procedure

1. 1
   Disconnect 1. the electrical connector.
2. 2
   Calibrate the brake pedal position sensor. Refer to Brake Pedal Position Sensor Calibration.

Headlamp Switch Replacement (Right Hand Drive)

Headlamp Switch Assembly

Procedure

1. 1
   Open the compartment to remove the headlamp switch.
2. 2
   Disconnect the electrical connection.

Fog Lamp Switch Replacement (Right Hand Drive)

Fog Lamp Switch

Procedure

1. 1
   Disconnect the electrical connection.
2. 2
   Squeeze tabs on switch to unsnap from housing bracket.

Hazard Warning Switch Replacement

Preliminary Procedure

Remove instrument panel accessory bezel. Refer to Instrument Panel Accessory Bezel Replacement.

Hazard Warning Switch

Procedure

1. 1
   Disconnect the electrical connection.
2. 2
   Unsnap switch from instrument panel accessory bezel.

Instrument Panel Lamp Dimmer Switch Replacement (Right Hand Drive)

Instrument Panel Lamp Dimmer Switch

Procedure

1. 1
   Disconnect electrical connector.
2. 2
   Squeeze tabs on switch to unsnap from housing bracket.

Reading Lamp Bulb Replacement

1. 1
   Dome and Reading Lamp Lens
2. 2
   Reading Lamp Bulb (Qty: 2)

Dome and Reading Lamp Lens Replacement

1. Dome and Reading Lamp Lens

Dome Lamp Replacement

Preliminary Procedure

Lower the headliner enough to gain access to the dome lamp housing. Refer to Headlining Trim Panel Replacement.

1. 1
   Dome Lamp Lens
2. 2
   Dome Lamp Switch Bezel
3. 3
   Dome Lamp Housing Assembly

Procedure

1. 1
   Carefully use a flat-bladed tool, and release the tabs retaining the dome lamp to the headliner.
2. 2
   Disconnect the electrical connector.

Dome Lamp Bulb Replacement

1. 1
   Dome and Reading Lamp Lens
2. 2
   Dome Lamp Bulb