Forward Lamp Wiring Harness Replacement

Preliminary Procedures

1. 1
   Remove the front bumper. Refer to Front Bumper Fascia Replacement.
2. 2
   Remove the headlamp. Refer to Headlamp Replacement.
3. 3
   Using a scan tool, check for DTCs.

Forward Lamp Wiring Harness

Tip

• Create a work area large enough to lay out the new and old wiring harnesses.
• Use care when removing inaccessible harness retainers. Replacement retainers may not be available.
• Compare the new and old wiring harnesses for the same part number, the same number of wiring harness connectors, the same pin settings, and the same harness retainers.
• Follow a logical order of steps during the replacement to ensure proper installation of the harness.

Rear License Plate Lamp Replacement

1. Rear License Plate Lamp Screw (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 3 N·m

2. Rear License Plate Lamp

Tip

Rotate the left corner of the lamp assembly upward and pull the right side down out from the rear bumper fascia opening.

3. Rear License Plate Lamp Socket

Tip

Rotate the lamp socket counterclockwise and remove.

4. Rear License Plate Lamp Bulb

Tip

Service the bulb, as needed.