Inflatable Restraint Side Impact Sensor Replacement

Warning: Refer to SIR Warning in the Preface section.

Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section.

Warning: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:

• The seat cushion frame
• The seat recliner, if equipped
• The seat adjuster
• The seat back frame

Failure to do so may cause future personal injury.

Preliminary Procedure

1. 1
   Disable the SIR system. Refer to SIR Disabling and Enabling
2. 2
   Remove center pillar lower garnish molding. Refer to Center Pillar Lower Garnish Molding Replacement

Inflatable Restraint Side Impact Sensor Screw

Caution: Refer to Fastener Caution in the Preface section.

Tighten 7,5 N·m

Inflatable Restraint Side Impact Sensor Assembly

Procedure

1. 1
   Disconnect electrical connector.
2. 2
   Loosen the bolts and slide the sensor out of the keyhole slots.

Tip

The bolt is integral to the sensor assembly, DO NOT remove separately.

Inflatable Restraint Sensing and Diagnostic Module Replacement

Preliminary Procedure

1. 1
   Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling.
2. 2
   Remove the instrument panel lower trim panel. Refer to Instrument Panel Lower Trim Panel Replacement - Left Side and Instrument Panel Lower Trim Panel Replacement - Right Side
3. 3
   Disconnect the electrical connector.

Inflatable Restraint Sensing and Diagnostic Module Nut (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 10 N·m

Inflatable Restraint Sensing and Diagnostic Module Assembly

Tip

If installing a replacement module, program the module. Refer to Control Module References