Installation Procedure

Create 6 x 20 mm (4/16 x 11/16 in) slots for MIG-brazing along the upper edges of the service panel as noted from the original panel.

Clean and prepare the attaching surfaces for brazing and spot welding.

Position the body lock pillar inner panel on the vehicle.

Verify the fit of the panel.

Clamp the body lock pillar inner panel into position.

Braze accordingly the body lock pillar inner panel upper.

Spot weld accordingly the body lock pillar inner panel lower.

Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair.

Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems.

Install all related panels and components.

Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.

Enable the SIR system. Refer to SIR Disabling and Enabling.