Chevrolet Cruze Quiz
Chevrolet Cruze Repair Manual

Installation Procedure

In this manual: Chevrolet Cruze Repair Manual
Chevrolet Cruze Owners Manual — 401Chevrolet Cruze Repair Manual — 520Radio — 10Audio Players — 5Bluetooth Phone/ Devices — 3Navigation — 13Introduction — 6Trademarks and License Agreements — 1Voice Recognition — 1
11steps
~66min
3/5difficulty
010203040502.52N·mlb·ft
Tightening torque found on this page
Done 0 of 11
Chevrolet Cruze. Installation Procedure
  1. Install the following components on the drivetrain and front suspension frame:
  • CH 49460-1 adapter (2).
  • CH 49460-2 adapter (4).
  • CH 6615-10 hydraulic cylinder (1).
  • NEW frame insulator (3)

Note: Check marking of frame insulator.

  1. Press carefully the frame insulator in to the front suspension frame, using CH 6616 hand pump .
  2. Remove the following components from the drivetrain and front suspension frame:
  • CH 49460-1 adapter .
  • CH 49460-2 adapter .
  • CH 6615-10 hydraulic cylinder .
  1. Install the drivetrain and front suspension frame. Refer to Drivetrain and Front Suspension Frame Replacement.

Front Wheelhouse Liner Replacement

Chevrolet Cruze. Front Wheelhouse Liner Replacement

Preliminary Procedure

Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

  1. Front Wheelhouse Liner Screw (Qty: 5)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2,5 N·m

  1. Front Wheelhouse Liner Plastic Retainer (Qty: 7)
  2. Front Wheelhouse Liner

Rear Wheelhouse Panel Liner Replacement

Chevrolet Cruze. Rear Wheelhouse Panel Liner Replacement

Preliminary Procedure

Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.

  1. Rear Wheelhouse Panel Liner Screw (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2,5 N·m

  1. Rear Wheelhouse Panel Liner Nut (Qty: 2)

Tighten 2,5 N·m

  1. Rear Wheelhouse Panel Liner Plastic Retainer (Qty: 2)
  2. Rear Wheelhouse Panel Liner

Front Fog Lamp Bezel Replacement

Chevrolet Cruze. Front Fog Lamp Bezel Replacement

Preliminary Procedure

  1. Remove front bumper fascia. Refer to Front Bumper Fascia Replacement.
  2. Remove front fog lamp. Refer to Front Fog Lamp Replacement.

Front Fog Lamp Bezel Screw

Caution: Refer to Fastener Caution in the Preface section.

Tighten 2,5 N·m

Front Fog Lamp Bezel

Procedure

  1. Disengage the 4 inner retainer tabs securing the bezel to the front bumper fascia.
  2. Pull outward from the outer edge in order to release the outer retention clips securing the bezel to the front bumper fascia.
  3. Remove the front fog lamp bezel.

Special Tools and Equipment

Chevrolet Cruze. Special Tools and Equipment

Test yourself

A quick Chevrolet Cruze quiz: every answer comes with an explanation and a link to the manual page.