Rear Side Door Window Adjustment

Warning: Refer to Glass and Sheet Metal Handling Warning in the Preface section.

Warning: Refer to Express Window Down Warning in the Preface section.

Preliminary Procedures

1. 1
   Remove the rear side door trim. Refer to Rear Side Door Trim Replacement.
2. 2
   Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement.
3. 3
   Rear Side Door Window Regulator Sash Nut (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten 10 N·m

2. Rear Side Door Window

Procedure

1. 1
   Loosen the window regulator sash nuts.
2. 2
   Connect the door trim panel wire connector.

Note: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.

1. 1
   Start the vehicle.
2. 2
   Using the power window switch, raise the window to the full up position.
3. 3
   Tighten the rear side door window regulator sash nuts.
4. 4
   Inspect for proper window operation and a tight seal.
5. 5
   Shut off the vehicle.