Windshield Washer Pump Replacement

Removal Procedure

1. 1
   Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement.
2. 2
   Disconnect the washer pump electrical connector (1).
3. 3
   Disconnect the washer pump hose (2) from the washer pump (3).
4. 4
   Using a small flat-bladed tool, remove the washer pump from the washer solvent container (5).
5. 5
   Drain the windshield washer solvent into a clean suitable container.
6. 6
   Using a small flat-bladed tool, remove the washer pump terminal seal (4) from the washer solvent container (1).

Installation Procedure

1. 1
   Position the washer pump terminal seal (4) to the washer solvent container (5), pressing in until fully seated.
2. 2
   Using full strength windshield washer solvent as a lubricant on the terminal seal, position the washer pump (3) to the washer solvent container (5) pressing in until fully seated.
3. 3
   Connect the washer pump electrical connector (1).
4. 4
   Connect the washer pump hose (2) to the washer pump (5).
5. 5
   Install the front wheelhouse panel splash shield. Refer to Front Wheelhouse Liner Replacement.
6. 6
   Fill the washer solvent container with washer solvent.
7. 7
   Inspect the washer system for proper operation.