Switches and Controls

GENERAL INFORMATION

Turn signal switch

The turn signals are activated by moving the combination lever up or

down until it stops.

When the steering wheel returns to the neutral position, the combination lever automatically returns to its original position, and the turn signals are cancelled at the same time.

cancelled.

To change lanes, move the combination lever up or down to the

intermediate non-latching position and hold it while performing the maneuver. After release, the lever returns to the center position.

Warning.

To prevent battery discharge, do not leave the lights

switched on with the engine off.

Headlight switch

To turn on the high beam, push the combination lever away from you (toward the instrument panel).

When the high beam is on, the corresponding indicator lamp illuminates on the instrument panel.

To turn on the high beam with the central light switch in any position, pull the combination lever toward the steering wheel. When released, the lever returns to its original position.

Windshield wiper switch

To turn on the windshield wiper, move the right

combination lever up.

The wiper operates with the ignition on.

OFF position: wiper off.

INT position: intermittent wiper operation.

LO position: continuous low-speed wiper operation.

HI position: continuous high-speed wiper operation.

Warning.

Do not operate the wiper when the windshield is dry. This may scratch the glass. Do not operate the wiper when the blades are clogged

with snow or frozen to the glass. This may damage the system.

wiper.

Windshield washer switch

The windshield washer is activated by pulling the right

combination lever toward you (the ignition must be on). Washer fluid is sprayed onto the glass as long as the lever is held in the

pulled position. The wiper switches on automatically together with the washer.

wiper, whose blades make four cycles. After releasing the lever, it

returns to its original position.

Rear window heater switch

The rear window heater is switched on by pressing the button (the ignition key

must be turned to position II). When the heater is switched on,

the corresponding indicator lamp illuminates. The heater can be

switched off by pressing the button again.

Warning.

To avoid damaging the heater element, do not use scrapers or other sharp tools, or cleaning agents containing abrasive

components, to clean the inside surface of the rear window.

Hazard warning switch

Press the button to turn on the hazard warning lights. To

turn off the hazard warning, press the button again.

When the hazard warning is on, all turn signals flash simultaneously, and both turn signal indicator lamps on the instrument panel flash in sync with them. The hazard warning works with the ignition both on and off.