Removal and Installation - Rear Lower Arm

Removal

NOTICE: Suspension fasteners are critical parts that affect the performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

1. 1
   Remove the coil spring.
   Refer to: Coil Spring (204-02 Rear Suspension, Removal and Installation).
2. 2
   Mark the position of the rear lower arm adjustment cam in relation to the crossmember.

   

3. 3
   Remove and discard the rear lower arm-to-subframe bolt, washer and nut, and remove the rear lower arm.

   

Installation

1. 1
   Position the rear lower arm and install a new rear lower arm-to-subframe bolt, washer and nut.
   Torque: 159 lb-in (18 N·m)

   

2. 2
   Install the coil spring.
   Refer to: Coil Spring (204-02 Rear Suspension, Removal and Installation).
3. 3

   NOTICE: Tighten the suspension fasteners with the vehicle weight on the wheels and tires, or use a suitable jack to raise the suspension to curb height, otherwise bushing damage may occur.

   Install the rear lower arm adjustment cam onto the crossmember bolt and nut.
   Torque: 111 lb-ft (150 N·m)

   

4. 4
   Check and, if necessary, adjust the rear wheel toe.
   Refer to: Rear Wheel Toe Adjustment (204-00 Suspension System - General Information, General Procedures).