Removal and Installation — Steering Column Shrouds

Special Service Tools / General Equipment

Removal

1. 1
   Fully extend and lower the steering column.

   

2. 2
   Release the upper finish gap retainer from the IPC and set aside.
   Use common service equipment: interior trim removal tool.

   

3. 3
   
   Release the front retainers of the upper steering column shroud.
   

   1. Turn the steering wheel 90 degrees to the left.

   2. Release the left clip.
      Use common service equipment: flat-blade screwdriver.

   3. Turn the steering wheel 180 degrees to the right.

   4. Release the right clip.
      Use common service equipment: flat-blade screwdriver.

   

4. 4
   Release the outer clips on each side and remove the upper steering column shroud.
   Use common service equipment: interior trim removal tool.

   

5. 5
   Position the steering column manual adjust lever to the lowest position.

   

6. 6
   Remove the bolts and the lower steering column shroud.

   

Installation

1. To install, reverse the removal procedure.