Compass Calibration

NOTE: For optimum calibration, drive to an open, level location away from large metallic objects or structures such as bridges, steel buildings, etc. Switch off all non-essential electrical accessories (heated rear window, heater fan, A/C, map lamps, and wipers) and make sure all doors are closed.

Start the vehicle.

NOTE: The vehicle remains in CAL mode until the compass has been successfully calibrated. NOTE:

While pressing and holding the Front Controls Interface Module (FCIM) preset buttons 7 and 9, the compass display first enters the ZONE setting mode (after 5 seconds) and then after another 5 seconds (10 seconds total), the compass display enters the CAL mode.

Press and hold the FCIM preset buttons 7 and 9 for approximately 10 seconds until the CAL indicator appears in the compass display, then release the buttons.

NOTE: If the CAL indicator does not turn off after the vehicle is driven in a circle at least 5 times, repeat the procedure.

Drive the vehicle slowly at less than 5 km/h in a continuous circle until the C or CAL indicator disappears from the display and the compass heading is displayed.

If the C or CAL indicator does not turn off after driving in a circle at least 5 times (and the procedure has been repeated at least once), install a new compass module (integral to the interior rear view mirror). For additional information, refer to Interior Rear View Mirror in Section 501-09.