Ford Focus Quiz
Powertrain

Transmission Range (TR) Sensor Adjustment

In this manual: Powertrain
Vehicle - General — 4Accessories — 40Body — 237Chassis — 113Electrical — 19HVAC — 44Powertrain — 292
~1min read
1special tools
01020304050107N·mlb·ft
Tightening torque found on this page
Special Tool(s)
Alignment Tool, Transmission Range Sensor 307-415
  1. Disconnect the Transmission Range (TR) sensor electrical connector and the selector lever cable.
  1. NOTE: Failure to hold the manual control lever while loosening or tightening the manual control lever bolt will transmit rotational torque to the TR sensor and shift mechanism.

    Loosen the TR sensor (automatic transaxle removed for clarity).

    1. Remove the manual control lever.
    1. Loosen the TR sensor bolts.
  1. Using the Transmission Range Sensor Alignment Tool, align the TR sensor and tighten the bolts.
    • Tighten to 10 N·m.
  1. NOTICE: Do not use air tools on this bolt. Hold the manual control lever while tightening the manual control lever bolt, failure to the manual control lever shaft or the Transmission Range (TR) sensor could occur.

    Install the manual control lever.

    • Tighten to 30 N·m.
  1. NOTICE: Check the manual control lever is in position 2 same as D position or the selector lever cable will not be adjusted correctly.

    Adjust the manual control lever to TR sensor D position.

    1. "L" Low
    1. "D" Drive
    1. "N" Neutral
    1. "R" Reverse
    1. "P" Park
    • When in position D, the marks on the manual control lever line up with the marks on the TR sensor.
  1. Connect the selector lever cable and the TR sensor electrical connector.

Test yourself

A quick Ford Focus quiz: every answer comes with an explanation and a link to the manual page.