Window Regulator Motor - Front Door

Remove the front door speaker. For additional information, refer to Section 415-00.

NOTE: Do not touch the adhesive surface during removal or installation of the watershield, as re-bonding will be impaired. If additional adhesive is required during installation, apply seam sealer as necessary to completely seal the watershield to the inner door.

Remove the watershield.

Temporarily install the window control switch to raise or lower the window to access the glass clamp bolts.

Loosen the 2 door window glass clamp bolts.

• To install, tighten to 8 N·m.

Tape the window in position, then lower the window regulator downward until it reaches the stops at the bottom of the regulator tracks.

Remove the front 3 regulator bolts.

• To install, tighten to 8 N·m.

Disconnect the window regulator motor electrical connector and remove the 3 regulator motor screws.

• To install, tighten to 4 N·m.

Remove the window regulator motor.

• Rotate the regulator motor to release the motor from the regulator assembly.

To install, reverse the removal procedure.