Ford Mustang Quiz
Engine

Evaporative Emission Test Port

In this manual: Engine
Service Information — 34Suspension — 63Driveline — 80Brake System — 74Steering System — 42Engine — 329Automatic Transmission — 84Manual Transmission, Clutch and Transfer Case — 64Exhaust System — 8Fuel System — 39Climate Control System — 76Instrumentation and Warning Systems — 25Battery and Charging System — 19Audio Systems — 14Lighting — 24Electrical Distribution — 8Electronic Feature Group — 11Body — 173Frame and Mounting — 6General Information — 1
~1min read

Removal and Installation

1. Disconnect the pin-type retainer.

Evaporative Emission Test Port

2. Raise and support the vehicle. For additional information, refer to Section.

3. Remove the RH front wheel. For additional information, refer to Section.

4. Remove the RH front splash shield.

1. Remove the three screws.

2. Remove the five pin-type retainers.

Evaporative Emission Test Port

5. Remove the evaporative emission test port by disconnecting at the EVAP canister purge outlet tube junction.

Evaporative Emission Test Port

6. To install, reverse the removal procedure.

  • Leak test the system. For additional information, refer to Evaporative Emission System Leak Test in this section.
  • Carry out the evaporative emission repair verification drive cycle. For additional information, refer to Evaporative Emission Repair Verification Drive Cycle in this section.

Evaporative Emission Canister Vent Solenoid

Removal and Installation

1. Remove the canister vent solenoid. For additional information, refer to Evaporative Emission Canister in this section.

Test yourself

A quick Ford Mustang quiz: every answer comes with an explanation and a link to the manual page.