Engine - 4.6L (2V)

General Specifications

a - With installation of a new filter.

b - Distance front edge of bearing is installed below front face of cylinder block.

c - Time necessary for plunger to leak down 1.6 mm of travel with 222 N force and leak down fluid in tappet.

d - Measured at 31.5 mm from top of block. Measured at 43 mm from top of piston, at 90 degrees to the piston pin.

e - Specification in 90.200 mm diameter gauge.

f - If applicable, measured vertically, +0.030-0.050 mm (0.001-0.002 inch) measured horizontally (oval pin bore).

g - Pin bore and crank bearing bore must be parallel and in same vertical plane within the specified total difference when measured at the ends of a 203 mm bar, 101.5 mm on each side of rod centerline.

Torque Specifications

a - Refer to the procedure in this section.