Installation

1. Install the lower intake manifold gaskets.

2. Connect the fuel charging wiring harness to the rear of the lower intake manifold and install the manifold.

3. Install the intake manifold fasteners and tighten in the sequence shown.

4. Position the fuel charging wiring harness and connect it to the fuel injection supply manifold in three places.

5. Connect the eight fuel injector electrical connectors.

6. Connect the electrical connector and the vacuum line to the fuel pressure sensor.

7. Install the generator. For additional information, refer to Section .

8. Install the coolant bypass tube. For additional information, refer to Section.

9. Connect the fuel line. For additional information, refer to Section.

10. Install the upper intake manifold. For additional information, refer to Intake Manifold-Upper in this section.