Removal

Both mounts

1. Disconnect the battery ground cable. For additional information, refer to Section.

2. Remove the coolant bypass tube. For additional information, refer to Section.

3. Rotate the drive belt tensioner clockwise and detach the drive belt from the generator pulley.

4. Disconnect the generator electrical connections.

5. Remove the bolts and the generator.

6. Install the special tool.

7. Using the special tool, support the engine.

8. Remove the front springs. For additional information, refer to Section.

9. NOTE: RH shown, LH similar.

Remove the six splash-shield pushpins.

10. Remove the 13 bolts and the cross-brace support.

11. NOTE: RH shown, LH similar.

Remove the two engine mount nuts.

12. Using two jackstands, support the subframe.

13. NOTE: Mark the bolts and the crossmember location for assembly reference.

Remove the four bolts.

14. NOTE: RH shown, LH similar.

Remove the four bolts.

15. Using the jackstands, lower the front subframe.

RH mount

16. Remove the nut and detach the wiring harness.

17. Remove the bolts, the studbolt and the engine mount.

LH mount

18. Remove the nuts and detach the ground cables.

19. Remove the bolt, the studbolts and the engine mount.