Retractor - Front Seat Safety Belt, Convertible

Special Tool(s)

Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A)

Removal

1. Remove the quarter trim panel (31012). For additional information, refer to Section.

2. Remove the nut and bolts and safety belt retractor.

Installation

NOTE: Make sure the safety belt is not twisted.

1. The shipping clip must remain attached prior to the installation of the retractor into the vehicle.

The clip must be removed after the retractor is installed.

2. Position the safety belt retractor. Install the nut and bolts.

3. The shoulder belt must pass through the belt holder on the top of the seatback

4. Install the quarter trim panel. For additional information, refer to Section.

5. Check the active restraint system for correct operation.