Retractor - Front Seat Safety Belt, Coupe

Special Tool(s)

Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A)

Removal

1. Remove the quarter trim panel (31012). For additional information, refer to Section.

2. Using the special tool, remove the bolt and the safety belt retractor.

• Remove the mastic seal.

3. Using the special tool, remove the safety belt anchor bolt.

4. Using the special tool, remove the D-ring bolt.

Installation

NOTE: Make sure the retractor tongue faces inboard.

NOTE: Make sure the safety belt is not twisted.

1. The shipping clip must remain attached prior to the installation of the retractor into the vehicle.The clip must be removed after the retractor is installed.

2. Position the safety belt anchor. Using the special tool, install the safety belt bolt.

3. Install a new mastic seal around the safety belt retractor before installing the retractor in the vehicle.

4. Position the safety belt retractor. Using the special tool, install the bolt.

5. Using the special tool, install the D- ring bolt.

6. Install the quarter trim panel. For additional information, refer to Section.

7. The shoulder belt must pass through the belt holder on the top of the seatback.

8. Check the active restraint system for correct operation.