Retractor - Rear Seat Safety Belt, Coupe

Special Tool(s)

Torx Bit, Safety Belt Bolt 501-010 (T77L-2100-A)

Removal

1. Remove the quarter trim panel (31012) and the angel wing trim. For additional information, refer to Section.

2. Using the special tool, remove the D-ring bolt.

3. Using the special tool, remove the bolt and the safety belt retractor (611B68).

4. Remove the bolt.

Installation

NOTE: Make sure the safety belt is not twisted when inserting it in the quarter trim panel.

1. Install the bolt.

2. Using the special tool, install the safety belt retractor and the bolt.

3. Using the special tool, install the D-ring bolt.

4. Install the quarter trim panel (31012) and the angel wing trim. For additional information, refer to Section.

5. Make sure the shoulder belt passes through the belt holder on the top of the seatback.

6. Check the active restraint system for correct operation.