Breather Line and Suction Line Inspection (Page-1)

Special Tools Required

• Fuel Pressure Gauge Attachment Set 07AAJ-S6MA150
• Vacuum Pump/Gauge, 0-30 inHg Snap-on YA4000A or equivalent, commercially available
• Vacuum/Pressure Gauge, 0-4 inHg 07JAZ-001000B

1. 1

   Remove the center console.

2. 2

   Remove the parking brake lever, then remove the access panel from the floor.

3. 3

   Disconnect the suction line (A) from the fuel tank unit, and connect a vacuum pump/gauge, 0-30 in Hg (B), to the hose as shown.

4. 4

   Start the engine, and check the vacuum:

   • If there is vacuum, go to step 5.

   • If there is no vacuum, replace the fuel filter.

5. 5

   Turn the ignition switch to LOCK (0).

6. 6

   Attach the fuel pressure gauge attachment. Then connect the vacuum pump/gauge (A) to the suction line (B), and apply vacuum to the line:

   • If the line holds vacuum, check for a blockage in the suction line. If there is a blockage, replace the suction line.

   • If the line does not hold vacuum, go to step 7.

7. 7

   Raise the vehicle on a lift.

8. 8

   Remove the fuel tank mount bracket (A).

9. 9

   Disconnect the breather line (A). Attach the fuel pressure gauge attachment, then plug the suction line (B) with a rubber cap (C).