Chassis Parking Brake Inspection In this manual: Chassis Vehicle General — 4Accessories — 103Body — 232Chassis — 83Electrical — 28HVAC — 26 13steps ~78min 3/5difficulty Done 0 of 13 Step-by-step mode Reset caution Frequent inhalation of brake shoe dust, regardless of material composition, could be hazardous to your health. Avoid breathing dust particles. Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner. 1Raise and support the vehicle.2Remove the rear wheels.3Release the parking brake, and remove the brake disc/drum.4Check the parking brake linings (A) for cracking, glazing, wear, and contamination.5Measure the parking brake lining thickness (B). Measurement does not include brake shoe thickness. Parking brake lining thickness: Standard: 3.4 mm (0.134 in) Service limit: 1.0 mm (0.039 in) 6If any part of the parking brake lining thickness is less than the service limit, replace all of the parking brake shoes as a set.7Check the hub (C) for smooth operation. If it requires servicing, replace the hub bearing unit.8Measure the inside diameter of the parking brake drum with an inside vernier caliper. Parking brake drum inside diameter: Standard: 210.0 mm (8.268 in) Service limit: 211.0 mm (8.307 in) 9If the inside diameter of the parking brake drum is more than the service limit, replace the brake disc/drum.10Check the parking brake disc/drum for scoring, grooves, and cracks.11Install the brake disc/drum and the brake caliper.12Do the major parking brake adjustment.13Clean the mating surfaces between the brake disc/drum and the inside of the wheel, then install the rear wheels. ← Previous Parking Brake Next → Parking Brake Inspection and Adjustment Was this page helpful?👍 Yes👎 No