Chassis

Reassembly

8steps
~48min
2/5difficulty
03060901201507052N·mlb·ft
Tightening torque found on this page
Done 0 of 8
  1. Install the damper spring (A) on the dust cover (B) by aligning the upper end (C) of the damper spring with the ledge portion (D) of the dust cover.

  2. Install the lower spring rubber on the damper spring.

  3. Install all the parts except the damper mounting washer (for some models) and the self-locking nut onto the damper unit (A) by referring to the Exploded View.

  4. Compress the damper spring using a strut spring compressor. Do not compress the spring excessively.

  5. Align the raised portion (A) of the lower spring rubber and the hole (B) of the lower spring seat on the damper unit (C).

    NOTE: After reassembling the damper/spring, install the dust cover (D) into the damper unit as shown.

  6. Align the angle of the stud (A) on the damper mounting base (B) and the damper bracket (C) as shown.

  7. Install the damper mounting washer (A) (for some models) and a new self-locking nut (B).

  8. Hold the damper shaft (C) using a hex wrench (D), and tighten the self-locking nut to the specified torque.

    NOTE: Different torque should be applied to the self-locking nut when the nut is tightened with or without the damper mounting washer.