Hyundai Elantra AD Quiz
Body (Interior and Exterior)

Front Seat Outer Cover Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 84Engine Electrical System — 60Emission Control System — 24Engine Control System/Fuel System — 90Automatic Transmission — 92Drive Shaft and Axle — 20Suspension System — 31Steering — 20Restraints — 50Brake System — 63Body (Interior and Exterior) — 214Body Electrical System — 221Heating, Ventilation, and Air Conditioning — 71
3steps
~18min
2/5difficulty
Done 0 of 3

Replacement
  • Wear gloves to avoid cutting your hands.
  • When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components.
  • Use a plastic panel removal tool to remove the interior trim parts without damaging the surface.
  • Be careful not to bend or scratch the trim and panels.
  1. Remove the front seat outer shield cover (A) by pulling forward in the direction of the arrow using a screwdriver or removal tool.
  2. Disconnect the front seat power switch connector (A).
  3. To install, reverse the removal procedure.
    • Make sure the connector is properly connected.
    • Replace any damaged clips (or pin-type retainers).

Test yourself

A quick Hyundai Elantra AD quiz: every answer comes with an explanation and a link to the manual page.