Glove Box Upper Cover Housing Repair Procedures

Replacement

Wear gloves to avoid cutting your hands.

When removing with a flat-blade screwdriver or removal tool, wrap the tools with protective tape to prevent damage to components. Use a plastic panel removal tool to remove the interior trim parts without damaging the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Remove the side cowl trim. (Refer to Interior Trim - "Side Cowl Trim")
2. 2
   Turn and remove both caps (B) from the glove box (A).

   

3. 3
   Separate the air damper (A) from the glove box (B).

   

4. 4
   Disconnect the latches (A) and remove the glove box (B).

   

5. 5
   Using a flat-tip screwdriver or trim removal tool, remove the crash pad side cover [RH] (A).

   

6. 6
   Using a flat-tip screwdriver or trim removal tool, remove the under cover [RH] (A).

   

7. 7
   Loosen the mounting screws and remove the airbag molding [RH] (A).

   

8. 8
   Loosen the mounting screws and remove the side garnish assembly [RH] (A).

   

9. 9
   Loosen the mounting screws and nuts, then remove the glove box upper cover assembly (A).

   

10. 10
    To install, reverse the removal procedure.

    Make sure the connector is properly connected. Replace any damaged clips (or pin-type retainers).